Acme Computing Corp. has remote sites in Port Clinton and Napoleon in addition to their main site in Toledo. There are currently 29 devices connected to the network in Toledo. The corporate plan is to link the Port Clinton and Napoleon offices to Toledo via T-1 lines. The remote offices which are due to open in the next 4 weeks will have a small number (less than 14) of devices connected to a LAN in each office. The corporation has obtained Cisco routers to deploy at the remote locations and a Cisco for use in Toledo (www.cisco.com). In the near future, Acme plans to connect to the Internet and Toledo will serve as the connection point.

1. Using this IPV6 network (2001:db1:4b62:400:: /64) design an IPv6 sub-network that will meet the needs of Acme Corporation

2. Using Cisco Packet Tracer complete the set-up of each router, switch, and PC in the Toledo-Napoleon-Port Clinton scenario. (Hint: Each location should have 1 router, 1 switch and 2 PCs. configure serial as well)

a. Each Router must use IPv6 Addressing

b. Each location must have a switch connected to an Ethernet port The switch does not need to have an IP address assigned

c. Each switch must have at least one PC connected using IPv6 addressing

3) Apply the configuration statements to enable static route entries to allow all devices on the inter-network to communicate?

4) Apply the configuration statements to enable IPv6 RIP dynamic routing protocol to allow all devices on the inter-network to communicate?

5) Apply the configuration statements to enable IPv6 OSPF dynamic routing protocol to allow all devices on the inter-network to communicate?

6) Create an IPv6 Extended ACL to block ping echo request from your network.

Please take screenshots of pinging, route table e.t.c,

copy and past the config table on a word document.

Will also like the full cisco packet tracer to confirm things for myself.